Dell PowerEdge T410 Hardware Owner's Manual - Page 36
DMA Controller, E2012 Memory - ram
View all Dell PowerEdge T410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Table 1-2. LCD Status Messages (continued) Code Text Causes Corrective Actions E2010 Memory not detected. No memory was detected in the system. Inspect DIMMs. Install or reseat memory modules. See "Installing Memory Modules" on page 110 or "Troubleshooting System Memory" on page 162. E2011 Memory Memory detected, but is configuration not configurable. Error failure. Check detected during memory DIMMs. configuration. See "Troubleshooting System Memory" on page 162. E2012 Memory Memory configured, but is See "Troubleshooting configured but unusable. System Memory" on unusable. page 162. Check DIMMs. E2013 BIOS unable to The system BIOS failed to See "Troubleshooting shadow memory. copy its flash image into System Memory" on Check DIMMs. memory. page 162. E2014 CMOS RAM CMOS failure. CMOS failure. Power RAM not functioning cycle AC. properly. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help" on page 185. E2015 DMA Controller DMA controller failure. failure. Power cycle AC. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help" on page 185. E2016 Interrupt Controller Interrupt controller failure. failure. Power cycle AC. Remove AC power to the system for 10 seconds and restart the system. If the problem persists, see "Getting Help" on page 185. 36 About Your System