Dell PowerEdge T410 Hardware Owner's Manual - Page 124
Disconnect all the cables from the system board and drives.
View all Dell PowerEdge T410 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 124 highlights
5 Disconnect all the cables from the system board and drives. NOTE: Note the routing of the power cables as you disconnect the cables from the system board and drives. You must route these cables properly when you replace them to prevent them from being pinched or crimped. 6 Remove the screws that secure the power supply to the chassis and slide the power supply out of the system. See Figure 3-17. Figure 3-17. Removing and Installing a Non-Redundant Power Supply 1 1 screws (3) 124 Installing System Components
124
Installing System Components
5
Disconnect all the cables from the system board and drives.
NOTE:
Note the routing of the power cables as you disconnect the cables
from the system board and drives. You must route these cables properly when
you replace them to prevent them from being pinched or crimped.
6
Remove the screws that secure the power supply to the chassis and slide
the power supply out of the system. See Figure 3-17.
Figure 3-17.
Removing and Installing a Non-Redundant Power Supply
1
screws (3)
1