Dell PowerEdge T430 Dell PowerEdge T430 Owners Manual - Page 58
Removing the optical drive or tape drive, Slot 1
View all Dell PowerEdge T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Slot 1 Slot 2 Slot 3 SATA optical drive or PowerVault RD1000 PowerVault RD1000 or blank SAS tape drive or blank Removing the optical drive or tape drive Prerequisites CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. 1. Ensure that you read the Safety instructions. 2. Follow the procedure listed in Before working inside your system. Steps 1. Disconnect the power and data cables from the back of the optical/tape drive. NOTE: Observe the routing of the power and data cable inside the chassis when you remove them from the system board and the optical/tape drive. You must route these cables correctly and in a similar manner when you replace them to prevent them from being pinched or crimped. 2. To remove the optical/tape drive, push the release latch as indicated in the figure. 3. Slide the optical/tape drive out of the drive bay. 4. If you are not immediately replacing the optical/tape drive, install the optical/tape drive blank. NOTE: Blanks must be installed on empty optical drive or tape drive slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system. NOTE: The procedure to install an optical/tape drive blank is similar to the procedure to install an optical/tape drive. 58