Dell PowerEdge T430 Dell PowerEdge T430 Owners Manual - Page 70
Installing a hard drive into a hard-drive carrier, Cabled hard drives
View all Dell PowerEdge T430 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Figure 23. Removing and installing a hard drive into a hard-drive carrier 1. screw (4) 3. hard-drive carrier 2. hard drive Installing a hard drive into a hard-drive carrier Prerequisites CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product. Keep the #2 Phillips screwdriver ready. Steps 1. Insert the hard drive into the hard-drive carrier with the connector end of the hard drive toward the back of the hard-drive carrier. 2. Align the screw holes on the hard drive with the screw holes on the hard-drive carrier. When aligned correctly, the back of the hard drive is flush with the back of the hard-drive carrier. 3. Attach the screws to secure the hard drive to the hard-drive carrier. Cabled hard drives Your system supports up to four 3.5 inch (SAS or SATA) cabled hard drives. Cabled hard drives are installed in an internal hard-drive bay. CAUTION: Do not turn off or restart your system while the hard drive is being formatted. Doing so can cause a hard drive failure. NOTE: Use only hard drives that have been tested and approved for use with your system. 70