Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 120

- add - Attach the network policy to an interface. - remove - Remove the network policy from an interface. - number - Enter a network policy index number (1 to 32). Configure advertise LLDP-MED network policies OS10(conf-if-eth1/1/5)# lldp-med network-policy add 1 Fast start repeat count Fast start repeat count enables a network connectivity device to advertise itself at a faster rate for a limited amount of time. The fast start timer starts when a network connectivity device receives the first LLDP frame from a newly detected endpoint. When an LLDP-MED endpoint is newly detected or connected to the network, the lldp-med fast-start-repeat-count command enables the network to quickly detect the endpoint. The LLDP-MED fast start repeat count specifies the number of LLDP packets that are sent during the LLDP-MED fast start period. By default, the device sends three packets per interval. Change the number of packets a device sends per second - up to 10. Rapid availability is crucial for applications such as emergency call service location (E911). • Enable fast start repeat count which is the number of packets sent during activation in CONFIGURATION mode (1 to 10, default 3). lldp-med fast-start-repeat-count number Configure fast start repeat count OS10(config)# lldp med fast-start-repeat-count 5 View LLDP configuration • View the LLDP configuration in EXEC mode. show running-configuration • View LLDP error messages in EXEC mode. show lldp errors • View LLDP timers in EXEC mode. show lldp timers • View the LLDP traffic in EXEC mode. show lldp traffic View running configuration OS10# show running-configuration View LLDP errors OS10# show lldp errors Total Memory Allocation Failures : 0 Total Input Queue Overflows : 0 Total Table Overflows : 0 View LLDP timers OS10# show lldp timers LLDP Timers: Holdtime in seconds: 120 Reinit-time in seconds: 2 Transmit interval in seconds: 30 120 Layer 2