Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 275
ip ospf retransmit-interval, ip ospf transmit-delay, log-adjacency-changes
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 275 highlights
ip ospf retransmit-interval Sets the retransmission time between lost LSAs for adjacencies belonging to the interface. Syntax ip ospf retransmit-interval seconds Parameters seconds - Enter a value in seconds as the interval between retransmission (1 to 3600). Default 5 seconds Command Mode INTERFACE Usage Information Set the time interval to a number large enough to avoid unnecessary retransmission. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/6)# ip ospf retransmit-interval 20 Supported Releases 10.2.0E or later ip ospf transmit-delay Sets the estimated time required to send a link state update packet on the interface. Syntax ip ospf transmit-delay seconds Parameters seconds - Set the time (in seconds) required to send a link-state update (1 to 3600). Default 1 second Command Mode INTERFACE Usage Information Set the estimated time required to send a link-state update packet. When you set the ip ospf transmitdelay value, take into account the transmission and propagation delays for the interface. The no version of this command resets the value to the default. Example OS10(conf-if-eth1/1/4)# ip ospf transmit-delay 5 Supported Releases 10.2.0E or later log-adjacency-changes Enables logging of syslog messages about changes in the OSPF adjacency state. Syntax Parameters Default Command Mode Usage Information Example log-adjacency-changes None Disabled ROUTER-OSPF The no version of this command resets the value to the default. OS10(config)# router ospf 10 OS10(conf-router-ospf-10)# log-adjacency-changes Supported Releases 10.2.0E or later Layer 3 275