Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 417
seq permit (MAC), seq permit icmp
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 417 highlights
Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 permit ipv6 any any capture session 1 Supported Releases 10.2.0E or later seq permit (MAC) Assigns a sequence number to permit MAC addresses while creating a filter. Syntax Parameters seq sequence-number permit {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} {nn:nn:nn:nn:nn:nn [00:00:00:00:00:00] | any} [protocol-number | capture | cos | vlan] • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing, from 1 to 16777214. • nn:nn:nn:nn:nn:nn - Enter the MAC address of the network from or to which the packets were sent. • 00:00:00:00:00:00 - (Optional) Enter which bits in the MAC address must match. If you do not enter a mask, a mask of 00:00:00:00:00:00 applies. • any - (Optional) Set all routes to be subject to the filter: - protocol-number - (Optional) Enter the protocol number identified in the MAC header, from 600 to ffff. - capture - (Optional) Enter the capture packets the filter processes. - cos - (Optional) Enter the CoS value, from 0 to 7. - vlan - (Optional) Enter the VLAN number, from 1 to 4093. Default Command Mode Usage Information Example Not configured MAC-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# mac access-list macacl OS10(conf-mac-acl)# seq 10 permit 00:00:00:00:11:11 00:00:11:11:11:11 any cos 7 OS10(conf-mac-acl)# seq 20 permit 00:00:00:00:11:11 00:00:11:11:11:11 any vlan 2 Supported Releases 10.2.0E or later seq permit icmp Assigns a sequence number to allow ICMP messages while creating the filter Syntax seq sequence-number permit icmp [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | dscp value| fragment] Access Control Lists 417