Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 72

Change hash algorithm The load-balancing command selects the hash criteria applied to load balancing of traffic on port-channels. If you do not obtain even traffic distribution, use the hash-algorithm command to select the hash scheme for LAG. Rotate or shift the L2-bit LAG hash until the desired traffic distribution is achieved. • Change the default (0) to another algorithm and apply it to LAG hashing in CONFIGURATION mode. hash-algorithm lag crc Change hash algorithm OS10(config)# hash-algorithm lag crc Configure interface ranges Bulk interface configuration allows you apply the same configuration to multiple interfaces - either physical or logical, or to display their current configuration. You can also create multiple logical interfaces in bulk. An interface range is a set of interfaces to which you can apply the same command. You can use interface ranges for: • Ethernet physical interfaces • Port channels • VLAN interfaces Bulk configuration excludes any non-existing interfaces in an interface range from the configuration. You can configure a default VLAN only if the interface range being configured consists of only VLAN ports. The interface range command allows you to create an interface range allowing other commands to be applied to that range of interfaces. Configure range of Ethernet addresses and enable them OS10(config)# interface range ethernet 1/1/1-1/1/5 OS10(conf-range-eth1/1/1-1/1/5)# no shutdown View the configuration OS10(conf-range-eth1/1/1-1/1/5)# show configuration ! interface ethernet1/1/1 no shutdown switchport access vlan 1 ! interface ethernet1/1/2 no shutdown switchport access vlan 1 ! interface ethernet1/1/3 no shutdown switchport access vlan 1 ! interface ethernet1/1/4 no shutdown switchport access vlan 1 ! interface ethernet1/1/5 no shutdown switchport access vlan 1 72 Interfaces