Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 404
permit ipv6, permit tcp
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 404 highlights
Command Mode Usage Information Example IPV4-ACL The no version of this command removes the filter. OS10(conf-ipv4-acl)# permit ip any any capture session 1 Supported Releases 10.2.0E or later permit ipv6 Configures a filter to permit all or specific packets from an IPv6 address. Syntax permit ipv6 [A::B | A::B/x | any | host ipv6-address] [A::B | A:B/x | any | host ipv6-address] [capture| dscp | fragment] Parameters • A::B - (Optional) Enter the source IPv6 address from which the packet was sent and the destination address. • A::B/x - (Optional) Enter the source network mask in /prefix format (/x) and the destination mask. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Enter to capture packets the filter processes. - dscp value - (Optional) Enter to deny a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Enter to use ACLs to control packet fragments. • host ipv6-address - Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter. OS10(conf-ipv6-acl)# permit ipv6 any any count capture session 1 Supported Releases 10.2.0E or later permit tcp Configures a filter to permit TCP packets meeting the filter criteria. Syntax permit tcp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [[A.B.C.D | A.B.C.D/x | any | host ip-address [operator] ] [ack | fin | psh | rst | syn | urg] [capture | dscp value | fragment] Parameters • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Permit a packet based on the DSCP values, 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. - ack - (Optional) Set the bit as acknowledgement. - fin - (Optional) Set the bit as finish-no more data from sender. - psh - (Optional) Set the bit as push. 404 Access Control Lists