Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 243
show hash-algorithm, Default, Command Mode, Usage Information, Example Ingress, Example IP, Selection
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 243 highlights
• l4-source-port - Enables the L4 source port information in the hash calculation. • mac-selection - Enables MAC load-balancing configurations. • destination-mac- Enables the destination MAC information in hash the calculation. • source-mac- Enables the source MAC information in the hash calculation. • ethertype - Enables the Ethernet type information in the hash calculation. Default • ip-selelection-source-ip dest-ip vlan-id l4-source-port l4-dest-port ipv4 protocol • ipv6-selection-source-ipv6 dest-ipv6 vlan-id l4-source-port l4-dest-port ipv6 protocol • mac-selection-source-mac destination-mac vlan-id ethertype • tcp-udp-selection-l4-source-port l4-dest-port Command Mode Usage Information CONFIGURATION • IPv4- selection: source-ip destination-ip protocol vlan-id l4-destination-port l4source-port • IPv6 destination address: source-ip destination-ip protocol vlan-id l4-destinationport l4-source-port • MAC parameters: source-mac destination-mac ethertype vlan-id • TCP/UDP parameters: l4-destination-port l4-source-port The no version of this command resets the value to the default. Example (Ingress) OS10(config)# load-balancing ingress-port enable Example (IP Selection) OS10(config)# load-balancing ip-selection destination-ip source-ip Supported Releases 10.2.0E or later show hash-algorithm Displays the hash-algorithm information. Syntax Parameters Default Command Mode Usage Information Example show hash-algorithm None Not configured EXEC None OS10# show hash-algorithm EcmpAlgo - crc LabAlgo - crc Supported Releases 10.3.0E or later Layer 3 243