Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 523
iscsi, iscsi session-monitoring enable, profile-storage
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 523 highlights
Command Mode Usage Information Example CONFIGURATION iSCSI traffic uses dot1p priority 4 in frame headers by default. Use this command to reconfigure the dot1p-priority bits advertised in iSCSI application TLVs. Enter only one dot1p-bitmap value - setting more than one bitmap value with this command is not supported. The default dot1p 4 value is advertised only if you enabled PFC pause frames for dot1p 4 traffic (pfc-cos dot1p-priority command). The no version of this command resets to the default value. OS10(config)# iscsi priority-bits 0x20 Supported Releases 10.3.0E or later iscsi profile-storage Configures a port for direct connection to a storage device that is not automatically detected by iSCSI. Syntax iscsi profile-storage storage-device-name Parameter storage-device-name - Enter a user-defined name of a storage array that iSCSI does not automatically detect. Default Not configured Command Mode INTERFACE Usage Information Configure directly attached storage arrays to be supported by iSCSI if they are not automatically detected. This command is required for storage devices that do not support LLDP. The no version of this command disables the connection. Example OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant Supported Releases 10.3.0E or later iscsi session-monitoring enable Enables iSCSI session monitoring. Syntax iscsi session-monitoring enable Parameter None Default Disabled Command Mode CONFIGURATION Usage Information Use the iscsi aging time command to configure the aging timeout in iSCSI monitoring sessions, and use the iscsi target port command to configure the TCP ports that listen for connected storage devices in iSCSI monitoring sessions. The no version of this command disables iSCSI session monitoring. NOTE: When iSCSI session monitoring is enabled, you can monitor a maximum of 100 connections. Example OS10(config)# iscsi session-monitoring enable Supported Releases 10.3.0E or later Converged data center services 523