Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 70
Minimum links, Assign Port Channel IP Address
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
• You cannot enable flow control on a port-channel interface - flow control is supported on physical interfaces that are port-channel members. • Port-channels support LACP (802.3ad). LACP identifies similarly configured links and dynamically groups ports into a logical channel. LACP activates the maximum number of compatible ports that the switch supports in a port-channel. If you globally disable spanning-tree operation, L2 interfaces that are LACP-enabled port-channel members may flap due to packet loops. Add port member - static LAG A static port-channel (LAG) contains member interfaces that you manually assign using the channel-group command. OS10(config)# interface port-channel 10 Aug 24 4:5:38: %Node.1-Unit.1:PRI:OS10 %dn_ifm %log-notice:IFM_ASTATE_UP: Interface admin state up.:port-channel10 Aug 24 4:5:38: %Node.1-Unit.1:PRI:OS10 %dn_ifm %log-notice:IFM_OSTATE_DN: Interface operational state is down.:port-channel10 OS10(conf-if-po-10)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# channel-group 10 Aug 24 4:5:56: %Node.1-Unit.1:PRI:OS10 %dn_ifm %log-notice:IFM_OSTATE_UP: Interface operational state is up.:port-channel10 Add port member - dynamic LACP LACP enables ports to be dynamically bundled as members of a port-channel. To configure a port for LACP operation, use the channelgroup mode command. Active and passive modes allow LACP to negotiate between ports to determine if they can form a port -channel based on their configuration settings. OS10(config)# interface port-channel 100 OS10(conf-if-po-10)# exit OS10(config)# interface ethernet 1/1/2 OS10(conf-if-eth1/1/2)# channel-group 100 mode active Minimum links Configure minimum links in a port-channel (LAG) that must be in oper up status to consider the port-channel to be in oper up status. • Enter the number of links in a LAG that must be in oper up status in PORT-CHANNEL mode (1 to 32, default 1). minimum-links number Configure minimum operationally up links OS10(config)# interface po 1 OS10(conf-if-po-1)# minimum-links 5 Assign Port Channel IP Address You can assign an IP address to a port channel and use port channels in L3 routing protocols. • Configure an IP address and mask on the interface in INTERFACE mode. ip address ip-address mask [secondary] - ip-address mask - Specify an IP address in dotted-decimal format (A.B.C.D) and the mask in slash format (/24). - secondary - Specify the IP address is the interface's backup IP address. You can configure up to eight secondary IP addresses. 70 Interfaces
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er2-5350827/70.png)