Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 405
permit tcp (IPv6
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 405 highlights
- rst - (Optional) Set the bit as reset. - syn - (Optional) Set the bit as synchronize. - urg - (Optional) Set the bit set as urgent. • operator - (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available: - eq - Equal to - gt - Greater than - lt - Lesser than - neq - Not equal to - range - Range of ports, including the specified port numbers. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Usage Information Example Not configured IPV4-ACL The no version of this command removes the filter. OS10(conf-ipv4-acl)# permit tcp any any capture session 1 Supported Releases 10.2.0E or later permit tcp (IPv6) Configures a filter to permit TCP packets meeting the filter criteria. Syntax Parameters permit tcp [A::B | A::B/x | any | host ipv6-address [eq | lt | gt | neq | range]] [A::B | A:B/x | any | host ipv6-address [eq | lt | gt | neq | range]] [ack | fin | psh | rst | syn | urg] [capture | dscp value | fragment] • A::B - Enter the IPv6 address in hexadecimal format separated by colons. • A::B/x - Enter the number of bits that must match the IPv6 address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Permit a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. • host ipv6-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# permit tcp any any capture session 1 Supported Releases 10.2.0E or later Access Control Lists 405