Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 345

Default Command Mode Usage Information Example Not configured INTERFACE The no version of this command disables broadcast. OS10(conf-if-eth1/1/1)# ntp broadcast client Supported Releases 10.2.0E or later ntp disable By default, NTP is enabled on all interfaces. Prevents an interface from receiving NTP packets. Syntax Parameters Default Command Mode Usage Information Example ntp disable None Enabled INTERFACE This command is used to configure OS10 to not listen to a particular server and prevents the interface from receiving NTP packets. The no version of this command re-enables NTP on an interface. OS10(conf-if-eth1/1/7)# ntp disable Supported Releases 10.2.0E or later ntp master Configures an NTP master server. Syntax Parameters Default Command Mode Usage Information Example ntp master stratum stratum - Enter the stratum number to identify the NTP server hierarchy (2 to 10). 8 CONFIGURATION The no version of this command resets the value to the default. OS10(config)# ntp master 6 Supported Releases 10.2.0E or later ntp server Configures an NTP time-serving host. Syntax Parameters ntp server {hostname | ipv4-address | ipv6-address} [key keyid] [prefer] • hostname - Enter the host name of the server. • ipv4-address | ipv6-address - Enter the IPv4 address (A.B.C.D) or IPv6 address (A::B) of the NTP server. • key keyid - (Optional) Enter the NTP peer key ID (1 to 4294967295). System management 345