Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 547
Syntax, Parameters, Default, Command Mode, Usage Information, Example, Supported Releases
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 547 highlights
location-led system Changes the location LED of the system. Syntax Parameters location-led system {node-id | node-id/unit-id} {on | off} • node-id | node-id/unit-id - Enter the system ID. • on | off - Set the system LED to be on or off. Default Command Mode Usage Information Example Not configured EXEC Use the location-led system command to change the location LED for the specified system ID. OS10# location-led system 1 on OS10# location-led system 1 off Supported Releases 10.3.0E or later ping Tests network connectivity to an IPv4 device. Syntax Parameters ping [-aAbBdDfhLnOqrRUvV] [-c count] [-i interval] [-I interface] [-m mark] [-M pmtudisc_option] [-l preload] [-p pattern] [-Q tos] [-s packetsize] [-S sndbuf] [-t ttl] [-T timestamp_option] [-w deadline] [-W timeout] [hop1 ...] destination • -a - (Optional) Audible ping. • -A - (Optional) Adaptive ping. An inter-packet interval adapts to the round-trip time so that not more than one (or more, if preload option is set) unanswered probe is present in the network. The minimum interval is 200 msec for a non-super-user, which corresponds to flood mode on a network with a low round-trip time. • -b - (Optional) Pings a broadcast address. • -B - (Optional) Does not allow ping to change the source address of probes. The source address is bound to the address used when ping starts. • -c count - (Optional) Stops the ping after sending the specified number of ECHO_REQUEST packets until the timeout expires. • -d - (Optional) Sets the SO_DEBUG option on the socket being used. • -D - (Optional) Prints the timestamp before each line. • -h - (Optional) View help for this command. • -i interval - (Optional) Enter the interval in seconds to wait between sending each packet (default 1 second). • -i interval- (Optional) Enter the number of seconds to wait before sending the next packet (0 to 60, default 1). • -I interface-address - (Optional) Enter the source interface address (with no spaces): - For a physical Ethernet interface, enter ethernetnode/slot/port; for example, ethernet1/1/1. - For a VLAN interface, enter vlanvlan-id; for example, vlan10. - For a loopback interface, enter loopbackid; for example, loopback1. - For a port-channel interface, enter port-channelchannel-id; for example, port-channel1. Troubleshoot OS10 547
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er2-5350827/547.png)