Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 127

Example OS10(conf-if-eth1/1/3)# lldp receive Supported Releases 10.2.0E or later lldp reinit Configures the delay time (in seconds) for LLDP to initialize on any interface. Syntax lldp reinit seconds Parameters seconds - Enter the delay timer value in seconds (1 to 10). Default 2 seconds Command Mode CONFIGURATION Usage Information The no version of this command resets the value to the default. Example OS10(config)# lldp reinit 5 Supported Releases 10.2.0E or later lldp timer Configures the rate (in seconds) at which LLDP packets send to the peers. Syntax lldp timer seconds Parameters seconds - Enter the LLDP timer rate in seconds (5 to 254). Default 30 seconds Command Mode CONFIGURATION Usage Information The no version of this command sets the LLDP timer back to its default value. Example OS10(config)# lldp timer 25 Supported Releases 10.2.0E or later lldp tlv-select basic-tlv Enables or disables TLV attributes to transmit and receive LLDP packets. Syntax lldp tlv-select basic-tlv {port-description | system-name | system-description | system-capabilities | management-address} Parameters • port-description - Enable or disable the port description TLV. • system-name - Enable or disable the system TLV. • system-description - Enable or disable the system description TLV. • system-capabilities - Enable or disable the system capabilities TLV. • management-address - Enable or disable the management address TLV. Default Enabled Layer 2 127