Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 492
delay-restore, discovery-interface, peer-routing
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 492 highlights
delay-restore Configures a time interval to delay the bringing up of VLT ports after reload or peer-link restoration between the VLT peer switches. Syntax delay-restore seconds Parameters seconds - Enter a delay time, in seconds, to delay bringing up VLT ports after the VLTi device is reloaded, from 1 to 1200. Default 90 seconds Command Mode VLT-DOMAIN Usage Information Use this command to delay the system from bringing up the VLT port for a brief period to allow L3 routing protocols to converge. If the peer VLT device was up at the time the VLTi link failed, use this command after a VLT device is reloaded. The no version of this command resets the delay time to the default value. Example OS10(conf-vlt-1)# delay-restore 100 Supported Releases 10.3.0E or later discovery-interface Configures the interface to discover and connect to a VLT peer in the VLT interconnect (VLTi) link between peers. Syntax discovery-interface {ethernet node/slot/port[:subport]} Parameters ethernet - Enter the Ethernet interface information for the port on a VLT peer. You can also enter a range of interfaces separated by hyphens. Default None Command Mode VLT-DOMAIN Usage Information The VLT node discovery service auto-LAGs the discovery ports and creates VLTi interfaces. The no version of this command disables the discovery-interface configuration. Example OS10(config)# vlt-domain 1 OS10(conf-vlt-1)# discovery-interface ethernet 1/1/15 Example (range) OS10(config)# vlt-domain 2 OS10(conf-vlt-2)# discovery-interface ethernet 1/1/1-1/1/12 Supported Releases 10.2.0E or later peer-routing Enables or disables L3 routing to peers. Syntax Parameters Default Command Mode peer-routing None Disabled VLT-DOMAIN 492 Virtual link trunking