Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 78
interface ethernet, interface loopback
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Command Mode Usage Information CONFIGURATION • Each breakout interface operates at the configured speed; for example, 10G or 25G. • The no interface breakout node/slot/port command resets a port to its default speed - 40G or 100G. • To configure breakout interfaces on a unified port, use the mode {Eth | FC} command in the Port-Group configuration mode. • On the MX9116n Fabric Engine and MX5108n Ethernet switch, the backplane server-facing ports do not support the interface breakout command. In show inventory media output, the status category of the backplane ports is displayed as FIXED. Example OS10(config)# interface breakout 1/1/41 map 10g-4x Supported Releases 10.2.2E or later interface ethernet Configures a physical Ethernet interface. Syntax Parameters Default Command Mode Usage Information Example interface ethernet node/slot/port:subport node/slot/port:subport - Enter the Ethernet interface information. Not configured CONFIGURATION The no version of this command deletes the interface. OS10(config)# interface ethernet 1/1/10:1 OS10(conf-if-eth1/1/10:1)# Supported Releases 10.2.0E or later interface loopback Configures a loopback interface. Syntax interface loopback id Parameters id - Enter the loopback interface ID number (0 to 16383). Default Not configured Command Mode CONFIGURATION Usage Information The no version of this command deletes the loopback interface. Example OS10(config)# interface loopback 100 OS10(conf-if-lo-100)# Supported Releases 10.2.0E or later 78 Interfaces
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er2-5350827/78.png)