Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 297

ipv6 ospf cost Changes the cost associated with the OSPFv3 traffic on an interface Syntax ipv6 ospf cost cost Parameters cost - Enter a value as the OSPFv3 cost for the interface (1 to 65335). Default Based on bandwidth reference Command Mode INTERFACE Usage Information If not configured, the interface cost is based on the auto-cost command. This command configures OSPFv3 over multiple vendors to ensure that all routers use the same cost value. The no version of this command removes the IPv6 OSPF cost configuration. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf cost 10 Supported Releases 10.3.0E or later ipv6 ospf dead-interval Sets the time interval since the last hello-packet was received from a router. After the interval elapses, the neighboring routers declare the router dead. Syntax Parameters Default Command Mode Usage Information Example ipv6 ospf dead-interval seconds seconds - Enter the dead interval value in seconds (1 to 65535). 40 seconds INTERFACE The dead interval is four times the default hello-interval by default. The no version of this command removes the IPv6 OSPF dead-interval configuration. OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf dead-interval 10 Supported Releases 10.3.0E or later ipv6 ospf hello-interval Sets the time interval between hello packets sent on an interface. Syntax ipv6 ospf hello-interval seconds Parameters seconds - Enter the hello-interval value in seconds (1 to 65535). Default 10 seconds Command Mode INTERFACE Usage Information All routers in a network must have the same hello time interval between the hello packets. The no version of the this command resets the value to the default. Example OS10(config)# interface vlan 10 OS10(conf-if-vl-10)# ipv6 ospf hello-interval 30 Supported Releases 10.3.0E or later Layer 3 297