Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 392

Example OS10(conf-if-eth1/1/8)# ip access-group testgroup in Supported Releases 10.2.0E or later ip access-list Creates an IP access list to filter based on an IP address. Syntax Parameters Default Command Mode Usage Information Example ip access-list access-list-name access-list-name - Enter the name of an IPv4 access list. A maximum of 140 characters. Not configured CONFIGURATION None OS10(config)# ip access-list acl1 Supported Releases 10.2.0E or later ip as-path deny Defines a BGP access list. Syntax Parameters ip as-path access-list name deny ASNumber • name - Enter the access list name, from 1 to 140. • ASNumber - Enter the AS number. Defaults Command Mode Usage Information Not configured CONFIGURATION You can specify an access list filter on both inbound and outbound BGP routes. Each filter is an access list based on regular expressions. If the regular expression matches the representation of the route AS path as an ASCII string, the permit or deny condition applies. The AS path does not contain the local AS number. The no version of this command removes a single access list entry if you specify deny and a regexp. Otherwise, the entire access list is removed. Example OS10(config)# ip as-path access-list abc deny 123 Supported Release 10.3.0E or later ip as-path permit Defines a BGP access-list. Syntax Parameters ip as-path access-list name permit ASNumber • name - Enter an access-list name, from 1 to 140. 392 Access Control Lists