Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 224
default-metric, bgp default local-preference, ebgp-multihop, Supported Releases, Syntax, Parameters
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 224 highlights
Supported Releases 10.3.0E or later default-metric Assigns a default-metric of redistributed routes to locally originated routes. Syntax Parameters Default Command Mode Usage Information Example (IPv4) default-metric number number - Enter a number as the metric to assign to routes from other protocols, from 1 to 4294967295. Disabled ROUTER-BGP Assigns a metric for locally-originated routes such as redistributed routes. After you redistribute routes in BGP, use this command to reset the metric value - the new metric does not immediately take effect. The new metric takes effect only after you disable and re-enable route redistribution for a specified protocol. To re-enable route distribution use the redistribute {connected [route-map map-name] | ospf process-id | static [route-map map-name]} command, or use the clear ip bgp * command after you reset BGP. The no version of this command removes the default metric value. OS10(conf-router-bgpv4-af)# default-metric 60 Example (IPv6) OS10(conf-router-bgpv6-af)# default-metric 60 Supported Releases 10.3.0E or later bgp default local-preference Changes the default local preference value for routes exchanged between internal BGP peers. Syntax default local-preference number Parameters number - Enter a number as the metric to assign to routes as the degree of preference for those routes. When routes compare, the route with the higher degree of preference or the local preference value is most preferred, from 1 to 4294967295. Default 100 Command Mode ROUTER-BGP Usage Information All routers apply this command setting within the AS. The no version of this command removes local preference value. Example OS10(conf-router-bgp-1)# default local-preference 200 Supported Releases 10.3.0E or later ebgp-multihop Allows EBGP neighbors on indirectly connected networks. Syntax ebgp-multihop hop count Parameters hop count - Enter a value for the number of hops, from 1 to 255. Default 1 224 Layer 3