Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 274

ip ospf network Sets the network type for the interface. Syntax ip ospf network {point-to-point | broadcast} Parameters • point-to-point - Sets the interface as part of a point-to-point network. • broadcast - Sets the interface as part of a broadcast network. Default Command Mode Usage Information Example Broadcast INTERFACE The no version of this command resets the value to the default. OS10(conf-if-eth1/1/1)# ip ospf network broadcast Supported Releases 10.2.0E or later ip ospf passive Configures an interface as a passive interface and suppresses routing updates (both receiving and sending) to the passive interface. Syntax Parameters Default Command Mode Usage Information Example ip ospf passive None Not configured INTERFACE You must configure the interface before setting the interface to Passive mode. The no version of the this command disables the passive interface configuration. OS10(conf-if-eth1/1/6)# ip ospf passive Supported Releases 10.2.0E or later ip ospf priority Sets the priority of the interface to determine the designated router for the OSPF network. Syntax Parameters Default Command Mode Usage Information Example ip ospf priority number number - Enter a router priority number (0 to 255). 1 INTERFACE When two routers attached to a network attempt to become the designated router, the one with the higher router priority takes precedence. The no version of this command resets the value to the default. OS10(conf-if-eth1/1/6)# ip ospf priority 4 Supported Releases 10.2.0E or later 274 Layer 3