Dell S5148F-ON OS10 Enterprise Edition User Guide Release 10.3.2E-R2 - Page 412
seq deny tcp
![]() |
View all Dell S5148F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 412 highlights
- fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 deny ipv6 any any capture session 1 Supported Releases 10.2.0E or later seq deny tcp Assigns a filter to deny TCP packets while creating the filter. Syntax Parameters seq sequence-number deny tcp [A.B.C.D | A.B.C.D/x | any | host ip-address [operator]] [[A.B.C.D | A.B.C.D/x | any | host ip-address [operator] ] [ack | fin | psh | rst | syn | urg] [capture | dscp value | fragment] • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: - capture - (Optional) Capture packets the filter processes. - dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. - fragment - (Optional) Use ACLs to control packet fragments. - ack - (Optional) Set the bit as acknowledgement. - fin - (Optional) Set the bit as finish-no more data from sender. - psh - (Optional) Set the bit as push. - rst - (Optional) Set the bit as reset. - syn - (Optional) Set the bit as synchronize. - urg - (Optional) Set the bit set as urgent. • operator - (Optional) Enter a logical operator to match the packets on the specified port number. The following options are available: - eq - Equal to - gt - Greater than - lt - Lesser than - neq - Not equal to - range - Range of ports, including the specified port numbers. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Not configured IPV4-ACL 412 Access Control Lists
![](/manual_guide/products/dell-powerswitch-s5148fon-os10-enterprise-edition-user-guide-release-1032er2-5350827/412.png)