HP Photosmart C6300 User Guide - Page 212

Solution 4: Make sure the sheets of paper are not stuck together Solution: Remove the paper from the photo tray and shuffle the paper so it does not stick together. Reload the paper into the photo tray and try printing again. Cause: Two or more pieces of paper were stuck together. If this did not solve the issue, try the next solution. Solution 5: Make sure the photo paper is not curled Solution: If the photo paper is curled, place the paper in a plastic bag and gently bend it the opposite direction of the curl until the paper lies flat. If the problem persists, use photo paper that is not curled. Cause: The photo paper was curled. If this did not solve the issue, try the next solution. Solution 6: Load one sheet of paper at a time Solution: Try loading just one sheet of photo paper in the photo tray at a time. Cause: Paper might not feed properly if you are using the product in an extremely high- or low-humidity environment. Photo tray cannot engage Solution: Remove the output tray, and then replace it. Push the output tray in as far as it will go. Make sure the output is lowered all the way and lays flat. Cause: The output tray was not inserted all the way. Photo tray cannot disengage Solution: Push the output tray all the way down. Cause: The output tray was not lowered all the way. Scan errors Review this section if you receive an error such as one of the following: • An error occurred communicating with the scanning device. • The scanning device could not be initialized. • The scanning device could not be found. • An internal error has occurred. • The computer cannot communicate with the scanning device. Errors 209 Troubleshooting