Intermec PM4i EasyADC for Microsoft Great Plains User's Manual - Page 115
To use the utility if you do NOT know the IP address of the WA22, Restore to factory defaults, Restore
![]() |
View all Intermec PM4i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 115 highlights
Chapter 6 - Troubleshooting 2 Choose Restore to factory defaults. 3 Enter the IP address. 4 Power cycle the WA22. 5 Click Restore. This could take up to a minute but the WA22 will be restored to defaults. To use the utility if you do NOT know the IP address of the WA22 1 Look at the WA22 configuration label to learn the WA22's Ethernet MAC address. 2 Specify the new IP address and the MAC address of the WA22. 3 Power cycle the WA22. 4 Click Set. 5 Perform the steps in the previous procedure to restore the WA22 to factory defaults. EasyADC System User's Manual 103
![](/manual_guide/products/intermec-pm4i-easyadc-microsoft-great-plains-users-manual-cee15ce/115.png)
Chapter 6 — Troubleshooting
EasyADC System User’s Manual
103
2
Choose
Restore to factory defaults
.
3
Enter the IP address.
4
Power cycle the WA22.
5
Click
Restore
. This could take up to a minute but the WA22 will be
restored to defaults.
To use the utility if you do NOT know the IP address of the WA22
1
Look at the WA22 configuration label to learn the WA22’s Ethernet
MAC address.
2
Specify the new IP address and the MAC address of the WA22.
3
Power cycle the WA22.
4
Click
Set
.
5
Perform the steps in the previous procedure to restore the WA22 to
factory defaults.