Kyocera FS-9120DN FS-9120DN/9520DN Operation Guide Rev-2 - Page 56
Operating the RAM Disk, Setting RAM Disk Size, RAM Disk Mode, MByte - 9520dn
View all Kyocera FS-9120DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Partition Size: The size of the written data in bytes. Partition Type: The type of the written data i.e., whether it is host data (Data) or font data (Font). When the list of file names (partition list) for the hard disk is printed, the message display returns to Ready. It also prints out the Directory Status List to confirm the directory or data that is written in PJL or KPDL (PostScript). 2.2.10 Operating the RAM Disk The RAM disk is a memory space shared within the printer memory that can temporarily store print jobs. The RAM disk can be used only for electronic sorting. The stored print job can then be used to print multiple copies of the job reducing the total amount of time required to print the whole job. It acts similarly to the hard disk except that the data is effective only when the printer is powered up. To set up the RAM disk, the option hard disk must not be installed. To use the RAM disk, activate and enter the desired size of the RAM disk in the manner described below. The maximum RAM disk size can be calculated as follows: FS-9120DN: Maximum RAM size = Total printer memory minus 36 MB FS-9520DN: Maximum RAM size = Total printer memory minus 24 MB For example, if the total memory installed in your printer (FS-9520DN) is 64 MB (Default), you can set 40 MB of RAM disk. If you attempt to set the RAM disk size beyond this restriction, the printer automatically rounds it down so that the size is always 24 MB less than the total printer memory. Once the RAM disk size is set, the printer must be reset. To activate RAM disk in the printer's memory, first you must use the printer's menu selection system. The printer's menu selection system allows you to perform the following operations on the RAM disk. • Setting RAM disk size • Reading data • Writing data • Deleting data • Printing of list of partitions By default, the RAM disk is not activated (Off). To confirm the RAM disk size or activate the RAM disk, proceed as follows: Chapter 3 Using the Operator Panel Setting RAM Disk Size 1 Press the MENU key. 2 Press the or key repeatedly until RAM Disk Mode > appears. RAM Disk Mode Off 3 Press the ENTER key. A blinking question mark (?) appears. RAM Disk Mode ? Off 4 Press the or key to select On. >RAM Disk Mode ? On 5 Press the ENTER key. A blinking question mark (?) disappears and > appears on the right side. RAM Disk Mode > On 6 Press the key. 7 Press the or key repeatedly until >RAM Disk Size appears. The data size also appears. >RAM Disk Size 0028 MByte 8 Press the ENTER key. A blinking cursor (_) appears. >RAM Disk Size 0028 MByte 9 Press the or key to display the desired size. Definable RAM disk size: 0001 to 1024 (display of size varies depending on the installed RAM size.) 10 Press the ENTER key. The selected RAM disk size is activated. 11 Press the MENU key. The message display returns to Ready. 3-35