Netgear DGND3300v2 User Manual - Page 128
Setting Up a Repeater Unit, Enable Wireless Repeating Function, Wireless Base, Station, Apply
View all Netgear DGND3300v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual Figure 68. 3. Select the Enable Wireless Repeating Function check box and the Wireless Base Station radio button. 4. Enter the MAC address for the repeater units. 5. Click Apply to save your changes. Setting Up a Repeater Unit Use a wired Ethernet connection to set up the repeater unit to avoid conflicts with the wireless connection to the base station. Note: If you are using the N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 base station with a non-NETGEAR N300 wireless modem router as the repeater, you might need to change additional configuration settings. In particular, you should disable the DHCP server function on the wireless repeater AP. To configure a N300 wireless modem router as a repeater unit: 1. If you are using the same model of N300 wireless modem router for both the base station and repeaters, you must change the LAN IP address for each repeater to a different IP address in the same subnet (see Using the LAN Setup Options on page 112). Note: Failing to change the LAN IP address will cause an IP address conflict in the network because the factory default LAN IP is the same for both units. 128 | Chapter 7. Advanced Settings (Part 1)