Netgear DGND3300v2 User Manual - Page 80
Setting Up a Client-to-Gateway VPN Configuration, Step 1: Con the Client-to-Gateway VPN Tunnel
View all Netgear DGND3300v2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 User Manual configuration mismatches between your N300 Wireless Dual Band ADSL2+ Modem Router DGND3300v2 and the corresponding VPN endpoint gateway or client workstation. Setting Up a Client-to-Gateway VPN Configuration Setting up a VPN between a remote PC running the NETGEAR ProSafe VPN client and a network gateway involves two steps, described in the following sections: • Step 1: Configure the Client-to-Gateway VPN Tunnel on page 80 describes how to use the VPN Wizard to configure the VPN tunnel between the remote PC and network gateway. • Step 2: Configure the NETGEAR ProSafe VPN Client on page 83 shows how to configure the NETGEAR ProSafe VPN client endpoint. IP: 192.168.3.1 22.23.24.25 VPN tunnel 0.0.0.0 Internet PC running NETGEAR ProSafe VPN client Figure 51. N300 Wireless Modem Router DGND3300v2 Client-to-Gateway VPN Tunnel Step 1: Configure the Client-to-Gateway VPN Tunnel This section describes using the VPN Wizard to set up the VPN tunnel using the VPNC default parameters listed in Table 2 on page 79. If you have special requirements not covered by these VPNC-recommended parameters, see Setting Up VPN Tunnels in Special Circumstances on page 100 for information about how to set up the VPN tunnel. The following worksheet identifies the parameters used in this procedure. For a blank worksheet, see Planning a VPN on page 78. Table 3. VPN Tunnel Configuration Worksheet Parameter Connection Name Pre-Shared Key Secure Association Perfect Forward secrecy Encryption Protocol Value to Be Entered Field Selection RoadWarrior N/A 12345678 N/A N/A Main Mode N/A Enabled N/A DES Manual Keys Disabled 3DES 80 | Chapter 6. Virtual Private Networking