Netgear GS110TP GS108T/ GS110TP Smart Switch Software Administration Manual - Page 122
MAC Address, VLAN ID, Interface, Clear, Refresh, Cancel
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 122 highlights
GS108T and GS110TP Smart Switch Software Administration Manual • MAC Address: Select MAC Address from the menu and enter a six-byte hexadecimal MAC address in two-digit groups separated by colons, then click Go. If the address exists, that entry will be displayed. An exact match is required. • VLAN ID: Select VLAN ID from the menu, enter the VLAN ID, for example, 100. Then click Go. If any entries with that VLAN ID exist they are displayed. • Interface: Select Interface from the menu, enter the interface ID in g1, g2... format, then, click Go. If any entries learned on that interface exist, they are displayed. 2. Click Clear to clear Dynamic MAC Addresses in the table. 3. Click Refresh to redisplay the page to show the latest MAC Addresses. 4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. The following table describes the information available for each entry in the address table. Field VLAN ID MAC Address Interface Status Description Specifies the VLAN ID on which the IGMP Snooping Querier is administratively enabled and for which VLAN exists in the VLAN database. A unicast MAC address for which the switch has forwarding and/or filtering information. The format is a six-byte MAC address with each byte separated by colons. For example, 00:0F:89:AB:CD:EF. The port where this address was learned: that is, this field displays the port through which the MAC address can be reached. The status of this entry. The possible values are: • Static: The entry was added when a static MAC filter was defined. • Learned: The entry was learned by observing the source MAC addresses of incoming traffic, and is currently in use. • Management: The system MAC address, which is identified with interface c1. Chapter 3: Configuring Switching Information | 55