Netgear GS110TP GS108T/ GS110TP Smart Switch Software Administration Manual - Page 128
CoS Interface Configuration, CoS tab, and then click the, Advanced, PORTS, Interface Trust Mode
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 128 highlights
GS108T and GS110TP Smart Switch Software Administration Manual CoS Interface Configuration Use the CoS Interface Configuration page to apply an interface shaping rate to all interfaces or to a specific interface. To display the CoS Interface Configuration page, click the QoS CoS tab, and then click the Advanced CoS Interface Configuration link. To configure CoS settings for an interface: 1. To configure CoS settings for a physical port, click PORTS. 2. To configure CoS settings for a Link Aggregation Group (LAG), click LAGS. 3. To configure CoS settings for both physical ports and LAGs, click ALL. 4. Select the check box next to the port or LAG to configure. You can select multiple ports and LAGs to apply the same setting to the selected interfaces. 5. From the Interface Trust Mode field, specify whether or not the selected interface(s) trust a particular packet marking when the packet enters the port. • Untrusted. Do not trust any CoS packet marking at ingress. • 802.1p. The eight priority tags that are specified in IEEE 802.1p are p0 to p7. The QoS setting lets you map each of the eight priority levels to one of four internal hardware priority queues: High, Normal, Low, and Lowest. • DSCP. The six most significant bits of the DiffServ field are called the Differentiated Services Code Point (DSCP) bits. 128 | Chapter 4: Configuring Quality of Service