Netgear GS110TP GS108T/ GS110TP Smart Switch Software Administration Manual - Page 162

GS108T and GS110TP Smart Switch Software Administration Manual The Profile Summary table shows the rules that are configured for the profile, as the following table describes. Field Description Rule Type Identifies the action the rule takes, which is either Permit or Deny. Service Type Displays the type of service to allow or prohibit from accessing the switch management interface: • SNMP • HTTP • HTTPS Source IP Address Displays the IP Address of the client that may or may not originate management traffic. Mask Displays the subnet mask associated with the IP address. Priority Displays the priority of the rule. The rules are validated against the incoming management request in the ascending order of their priorities. If a rule matches, action is performed and subsequent rules below are ignored. Click Refresh to update the page with the most current information. Access Rule Configuration Use the Access Rule Configuration page to configure the rules about what systems can access the GS108T or GS110TP Web interface and what protocols are allowed. To access the Access Rule Configuration page, click Security  Access, and then click the Access Control  Access Rule Configuration link. 162 | Chapter 5: Managing Device Security