Netgear GS110TP GS108T/ GS110TP Smart Switch Software Administration Manual - Page 64
LLDP-MED Port Settings, System, Advanced, LLDP-MED Status, Notification, Apply, Cancel
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 64 highlights
GS108T and GS110TP Smart Switch Software Administration Manual LLDP-MED Port Settings Use this page to enable LLDP-MED mode on an interface and configure its properties. To display this page, click System LLDP Advanced LLDP-MED Port Settings. To configure LLDP-MED settings for a port: 1. From the Port field, select the port to configure. 2. From the LLDP-MED Status field, enable or disable the LLDP-MED mode for the selected interface. 3. From the Notification field, specify whether the port should send a topology change notification if a device is connected or removed. 4. From the Transmit Optional TLVs field, specify whether the port should transmit optional type length values (TLVs) in the LLDP PDU frames. If enabled, the following LLDP-MED TLVs are transmitted: • MED Capabilities • Network Policy • Location Identification • Extended Power via MDI: PSE • Extended Power via MDI: PD • Inventory 5. Click Apply to send the updated configuration to the switch. These changes occur immediately and the configuration will be saved. 6. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 64 | Chapter 2: Configuring System Information