Netgear GS110TP GS108T/ GS110TP Smart Switch Software Administration Manual - Page 61
LLDP Port Settings, Management IP Address.
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
GS108T and GS110TP Smart Switch Software Administration Manual LLDP Port Settings Use the LLDP Port Settings page to specify LLDP parameters that are applied to a specific interface. To display the LLDP Port Settings page, click SystemLLDP Advanced LLDPPort Settings. To configure LLDP port settings: 1. Change the LLDP port settings described below: • Interface. Specifies the port to be affected by these parameters. • Admin Status. Select the status for transmitting and receiving LLDP packets: • Tx Only: Enable only transmitting LLDP PDUs on the selected ports. • Rx Only: Enable only receiving LLDP PDUs on the selected ports. • Tx and Rx: Enable both transmitting and receiving LLDP PDUs on the selected ports. • Disabled: Do not transmit or receive LLDP PDUs on the selected ports. • Management IP Address. Choose whether to advertise the management IP address from the interface. The possible field values are: • Stop Advertise: Do not advertise the management IP address from the interface. • Auto Advertise: Advertise the current IP address of the device as the management IP address. • Notification. When notifications are enabled, LLDP interacts with the Trap Manager to notify subscribers of remote data change statistics. The default is Disabled. Chapter 2: Configuring System Information | 61