Netgear GS110TP GS108T/ GS110TP Smart Switch Software Administration Manual - Page 123
Dynamic Address Configuration, Switching, Address Table, Advanced, Dynamic, Addresses, Cancel, Apply
UPC - 606449069129
View all Netgear GS110TP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 123 highlights
GS108T and GS110TP Smart Switch Software Administration Manual Dynamic Address Configuration Use the Dynamic Addresses page to set the amount of time to keep a learned MAC address entry in the forwarding database. The forwarding database contains static entries, which are never aged out, and dynamically learned entries, which are removed if they are not updated within a given time. To access the Configuration page, click Switching Address Table Advanced Dynamic Addresses. To configure the Dynamic Address setting: 1. Specify the number of seconds the forwarding database should wait before deleting a learned entry that has not been updated. IEEE 802.1D-1990 recommends a default of 300 seconds. You may enter any number of seconds between 10 and 1000000. The factory default is 300. Note: IEEE 802.1D recommends a default of 300 seconds, which is the factory default. 2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the latest value of the switch. 3. Click Apply to apply to send the updated configuration to the switch. Configuration changes take effect immediately. 56 | Chapter 3: Configuring Switching Information