Yamaha AW2816 Owner's Manual - Page 188
As necessary, use the WRITE SPEED buttons, and following of the CD.
View all Yamaha AW2816 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 188 highlights
7 Move the cursor to the stereo track information in the list, and use the [DATA/JOG] dial to select the stereo track that will be written to track 1. In this list, it is not possible to select stereo tracks that are part of a 48 kHz sampling frequency song, or the stereo track of a current song that has not been saved on the hard disk. In addition, there may be cases in which it will not be possible to select the stereo track of a song that has not been optimized. (For details on the Optimize operation, refer to page 154.) 8 If you want to permit digital copying of the track you selected in step 7, move the cursor to the COPYRIGHT button located in the lower part of the screen, and press the [ENTER] key. The COPYRIGHT button specifies whether copyprohibit flags will be written into the sub-code channel of the CD. If the button is set to PROHIBIT, the COPY column of corresponding track will show a symbol, and digital copying of that track will be prohibited. If you switch the COPYRIGHT button to the PERMIT setting, digital copying of that track will be permitted. 9 Repeat steps 6-8 to select the stereo tracks that you want to write to track numbers 2 and following of the CD. Tip! • If you move the cursor to the NEW button and press the [ENTER] key, a new track will be added following the last track number. • If you use the INS button instead of the NEW button, a new track will be inserted before the currently selected track number. • If you use the DEL button, the currently selected track number will be deleted from the list. When you use the NEW button or INS button to add a track number, the same stereo track will be always selected as the initial setting. Be careful that you do not inadvertently select the same stereo track twice. 10 As necessary, use the WRITE SPEED buttons in the lower left of the display to specify the writing speed. The x1/x2/x4/x6 buttons correspond to single, 2x, 4x, and 6x writing speeds. Normally you should select the fastest speed that your CD-RW drive supports. If errors occur repeatedly during writing, select a slower writing speed. 11 When you have finished selecting all the stereo tracks that will be written to the CD, move the cursor to the EXECUTE button in the lower right of the display, and press the [ENTER] key. A popup window will ask you to confirm execution of the mastering operation. Mastering 12 Operation section 183