Yamaha AW2816 Owner's Manual - Page 284
BALL button CREQUEST button DTRANSMIT button EINTERVAL, AW2816
View all Yamaha AW2816 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 284 highlights
MIDI screen B ALL button When you move the cursor to this button and press the [ENTER] key, all of the buttons in the (1) area will be on. In addition, categories for which the transmitted content can be specified (SCENE MEM.-REMOTE) will be set to the "ALL" selection. C REQUEST button When you move the cursor to this button and press the [ENTER] key, a "Bulk Dump Request" message will be sent from the MIDI OUT/TO HOST connector, requesting the bulk dump data that you selected in (1). Use this function when you have connected the MIDI IN/MIDI OUT connectors of two AW2816 units to each other, and want to copy scene memories or libraries from one AW2816 to the other. E INTERVAL This specifies the interval that will be left between data blocks when a bulk dump is transmitted from the AW2816. This setting can be made in 1 millisecond increments over a range of 0-300 milliseconds. (Default setting= 0) Tip! Depending on the device that is receiving the bulk dump data, errors may occur during bulk dump reception. If this occurs, try increasing the INTERVAL (5) setting. If a bulk dump is being performed between two AW2816 units, leave the INTERVAL setting at zero. The time required for receiving or transmitting a bulk dump will depend on the selected category and the recorded data. In particular in the case of automix, be aware that a longer time may be required depending on how much data has been recorded. AW2816 Bulk dump: reception on MIDI OUT Bulk dump data MIDI IN MIDI IN Request message MIDI OUT AW2816 Bulk dump: reception on D TRANSMIT button When you move the cursor to this button and press the [ENTER] key, the bulk dump data selected in (1) will be transmitted from the MIDI OUT/TO HOST connector. Use this when you want to save bulk dump data on an external device such as a MIDI sequencer. Before transmitting bulk dump data or bulk dump request messages to the AW2816, you must turn Bulk Dump Data Reception "on" in the MIDI screen MIDI Setup 1 page. 282 Reference section