D-Link DGS-3200-16 User Manual - Page 175
Add Access Rule window for Packet Content, Access ID 1
UPC - 790069312007
View all D-Link DGS-3200-16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 175 highlights
xStack® DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch Figure 6 - 20. Add Access Rule window for Packet Content To set the Access Rule for Packet Content, adjust the following parameters and click Apply. Parameter Access ID (1200) Action Priority (0-7) Replace Priority Replace DSCP (0-63) Chunk Rx Rate (1- Description Type in a unique identifier number for this access. This value can be set from 1 to 200. Auto Assign - Ticking this check box will instruct the Switch to automatically assign an Access ID for the rule being created. Select Permit to specify that the packets that match the access profile are forwarded by the Switch, according to any additional rule added (see below). Select Deny to specify that packets that do not match the access profile are not forwarded by the Switch and will be filtered. Select Mirror to specify that packets that match the access profile are mirrored to a port defined in the config mirror port command. Port Mirroring must be enabled and a target port must be set. Tick the corresponding check box if you want to re-write the 802.1p default priority of a packet to the value entered in the Priority field, which meets the criteria specified previously in this command, before forwarding it on to the specified CoS queue. Otherwise, a packet will have its incoming 802.1p user priority re-written to its original value before being forwarded by the Switch. For more information on priority queues, CoS queues and mapping for 802.1p, see the QoS section of this manual. Tick this check box to replace the Priority value in the adjacent field. Select this option to instruct the Switch to replace the DSCP value (in a packet that meets the selected criteria) with the value entered in the adjacent field. When an ACL rule is added to change both the priority and DSCP of an IPv4 packet, only one of them can be modified due to a chip limitation. Currently the priority is changed when both the priority and DSCP are set to be modified. This field will instruct the Switch to mask the packet header beginning with the offset value specified. Use this to limit Rx bandwidth for the profile being configured. This rate is implemented using the following equation: 1 value = 64kbit/sec. (ex. If the user selects an Rx rate of 10 then the ingress 162