D-Link DGS-3200-16 User Manual - Page 29

xStack® DGS-3200 Series Layer 2 Gigabit Ethernet Managed Switch System Log Host The Switch can send Syslog messages to up to four designated servers using the System Log Server. To view the following window, click Configuration > System Log Configuration > System Log Host: Figure 2- 16. System Log Host window The following parameters may be configured or viewed: Parameter Description Host ID Host IP Address UDP Port (514 or 6000-65535) Severity Facility Status Syslog server settings index (1 to 4). The Ipv4 address of the Syslog server. Type the UDP port number used for sending Syslog messages. The default is 514. This drop-down menu allows you to select the level of messages that will be sent. The options are Warning, Informational, and All. Use the drop-down menu to select Local 0, Local 1, Local 2, Local 3, Local 4, Local 5, Local 6, or Local 7. Choose Enabled or Disabled to activate or deactivate. To set the System Log Server configuration, click Apply. To delete an entry from the System Log Host List table, click the corresponding Delete button next to the entry. System Severity Settings The Switch can be configured to allow alerts be logged or sent as a trap to an SNMP agent or both. The level at which the alert triggers either a log entry or a trap message can be set as well. Use the System Severity Settings window to set the criteria for alerts. The current settings are displayed below the System Severity Table. To view the following window, click Configuration > System Severity Settings: Figure 2 - 17. System Severity Settings window The following parameters may be configured or viewed: 16