D-Link DGS-3620-28TC-SI Product Manual - Page 121
MLD Proxy, MLD Proxy Settings, MLD Proxy Downstream Settings
View all D-Link DGS-3620-28TC-SI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide MLD Proxy MLD Proxy Settings This window is used to configure the MLD proxy state and MLD proxy upstream interface. To view the following window, click L2 Features > L2 Multicast Control > MLD Proxy > MLD Proxy Settings, as show below: Figure 4-65 MLD Proxy Settings window The fields that can be configured are described below: Parameter Description MLD Proxy State Use the radio buttons to enable or disable the MLD Proxy Global State. VLAN Name Click the radio button and enter the VLAN name for the interface. VID Click the radio button and enter the VLAN ID for the interface. Source IP Address Enter the source IPv6 address of the upstream protocol packet. If it is not specified, zero IP address will be used as the protocol source IP address. Unsolicited Report Interval (0-25) The Unsolicited report interval. It is the time between repetitions of the host's initial report of membership in a group. Default is 10 seconds. If set to 0, it means to send only one report packet. Unit Select the unit you wish to configure. Static Router Port Select the port that will be included in this configuration. Click the Apply button to accept the changes made for each individual section. Click the Select All button to select all the ports for configuration. Click the Clear All button to unselect all the ports for configuration. MLD Proxy Downstream Settings This window is used to configure the MLD proxy downstream interface in this page. The MLD proxy downstream interface must be an MLD snooping enabled VLAN. To view the following window, click L2 Features > L2 Multicast Control > MLD Proxy > MLD Proxy Downstream Settings, as show below: 111