D-Link DGS-3620-28TC-SI Product Manual - Page 169

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Parameter Description IP Address Enter the source IP address of the received IP multicast packet matches this network, the RPF address is used to do RPF check. Subnet Mask Enter the subnet mask of the above specified IP address. If the source IP address of the received IP multicast packet matches the IP address and subnet mask, RPF address will be used to check whether packets are received from legal interface. RPF Address Enter the RPF address. If the source IP address of the received IP multicast packet matches the IP address and subnet mask, RPF address will be used to check whether packets are received from legal interface. Click the Add button to add a new entry based on the information entered. Click the Find button to locate a specific entry based on the information entered. Click the View All button to display all the existing entries. Click the Delete All button to remove all the entries listed. Click the Delete button to remove the specific entry. Route Preference Settings This window is used to configure the route type preference. The route with smaller preference has higher priority. The preference for local routes is fixed to 0. To view the following window, click L3 Features > Route Preference Settings, as shown below: Figure 5-11 Route Preference Settings window Click the Apply button to accept the changes made. ECMP Algorithm Settings This window is used to configure the ECMP OSPF state and ECMP route load-balancing algorithm. To view the following window, click L3 Features > ECMP Algorithm Settings, as shown below: 159