D-Link DGS-3620-28TC-SI Product Manual - Page 228
PIM SSM Settings, PIM for IPv6 (EI Mode Only), PIM for IPv6 Global Settings
View all D-Link DGS-3620-28TC-SI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 228 highlights
xStack® DGS-3620 Series Managed Switch Web UI Reference Guide This window is used to display list all the RP-Set information. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM RP-Set Table, as shown below: Figure 5-90 PIM RP-Set Table window Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. PIM SSM Settings This window is used to enable the SSM (Source-Specific Multicast) service model in PIM-SM on the Switch. The PIM-SSM function will take active only when SSM service model and PIM-SM state both enabled. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv4 > PIM SSM Settings, as shown below: Figure 5-91 PIM SSM Settings window The fields that can be configured are described below: Parameter Description SSM Service Model State Click the radio buttons to enable or disable the SSM service model on the Switch. SSM Group Address Enter the group address range for the SSM service in IPv4. Tick the Default check box to indicate that the group address range is 232.0.0.0/8. SSM Group Mask Enter the netmask of the SSM group. Click the Apply button to accept the changes made. PIM for IPv6 (EI Mode Only) PIM for IPv6 Global Settings This window is used to set the PIM for IPv6 multicast protocol state and some related parameters in the protocol on some interfaces. To view the following window, click L3 Features > IP Multicast Routing Protocol > PIM > PIM for IPv6 > PIM for IPv6 Global Settings, as shown below: 218