D-Link DGS-3620-28TC-SI Product Manual - Page 204

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter Description Hello Interval (1-65535) Enter the interval time between the transmissions of OSPFv3 Hello packets, in seconds. The Hello Interval and Dead Interval should be the same for all routers on the same link. The default value is 10. Dead Interval (1-65535) Enter the interval time between the receipts of Hello packets from a neighbor router before the selected area declares that router down. The Dead Interval must be evenly divisible by the Hello Interval. Instance ID (0-255) Enter the instance ID of the interface. The default value is 0. Click the Apply button to accept the changes made. Click the OSPFv3 > OSPFv3 Area Aggregation Settings, as shown below: Figure 5-54 OSPFv3 Area Aggregation Settings window The fields that can be configured are described below: Parameter Description Area ID Enter a 32-bit number in the form of an IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain. IPv6 Address/Prefix Length Enter the IPv6 network address of the aggregation. Advertise Use the drop-down menu to specify whether the OSPFv3 ABR will use this aggregation to aggregate the intra-area routes or not. Click the Apply button to accept the changes made. Click the Edit button to re-configure the selected entry. Click the Delete button to remove the selected entry. OSPFv3 LSDB Table This window is used to display the OSPFv3 Link State Database (LSDB). To view the following window, click L3 Features > OSPF > OSPFv3 > OSPFv3 LSDB Table, as shown below: 194