D-Link DGS-3620-28TC-SI Product Manual - Page 170

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Figure 5-12 ECMP Algorithm Settings window The fields that can be configured are described below: Parameter Description ECMP OSPF State Click the radio buttons to enable or disable the ECMP OSPF state. Destination IP Tick the check box so that the ECMP algorithm will include the destination IP. Source IP Tick the check box so that the ECMP algorithm will include the lower 5 bits of the source IP. This attribution is mutually exclusive with CRC Low and CRC High. If it is set, CRC Low and CRC High will be excluded. CRC Low Tick the check box so that the ECMP algorithm will include the lower 5 bits of the CRC. This attribution is mutually exclusive with Source IP and CRC High. If it is set, Source IP and CRC High will be excluded. CRC High Tick the check box so that the ECMP algorithm will include the upper 5 bits of the CRC. This attribution is mutually exclusive with Source IP and CRC Low. If it is set, Source IP and CRC Low will be excluded. TCP/UDP Port Tick the check box so that the ECMP algorithm will include the TCP or UDP port. Click the Apply button to accept the changes made for each individual section. Route Redistribution Settings This window is used to redistribute the routing information from other routing protocols to RIP, OSPF or BGP. To view the following window, click L3 Features > Route Redistribution Settings, as shown below: Figure 5-13 Route Redistribution Settings The fields that can be configured are described below: Parameter Description Destination Protocol Source Protocol Type Use the drop-down menu to select the destination protocol. Use the drop-down menu to select the source protocol. When OSPF is select in the Source Protocol drop-down menu, this is able to configure. All - To redistribute both OSPF AS-internal and OSPF AS-external routes to RIP. Internal - To redistribute only the OSPF AS-internal routes. 160