D-Link DGS-3620-28TC-SI Product Manual - Page 202

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Figure 5-50 OSPFv3 Interface Settings window The fields that can be configured are described below: Parameter Description Interface Name Enter the OSPFv3 IP interface name. Click the Find button to find the interface entered. Click the View All button to view all the interfaces configured on this switch. Click the Edit button to re-configure the selected entry. After clicking the Edit button, the following window will appear. Figure 5-51 OSPFv3 Interface Settings - Edit window The fields that can be configured are described below: Parameter Description Area ID Enter a 32-bit number in the form of an IPv4 address that uniquely identifies the OSPFv3 area in the OSPFv3 domain. Priority (0-255) Enter the priority used in the election of the Designated Router (DR). It is a number between 0 and 255. Its default value is 1. Hello Interval (1-65535) Enter the interval time between the transmissions of OSPFv3 Hello packets, in seconds. The Hello Interval and Dead Interval should be the same for all routers on the same link. The default value is 10. Dead Interval (1-65535) Enter the interval time between the receipts of Hello packets from a neighbor router before the selected area declares that router down. The Dead Interval must be evenly divisible by the Hello Interval. Instance ID (0-255) Enter the instance ID of the interface. The default value is 0. Metric (1-65535) Enter the field that allows the entry of a number between 1 and 65535 that is the representative of the OSPFv3 cost of reaching the selected OSPFv3 interface. The default value is 10. 192