D-Link DGS-3620-28TC-SI Product Manual - Page 48

xStack® DGS-3620 Series Managed Switch Web UI Reference Guide Management Settings Users can stop the scrolling of multiple pages beyond the limits of the console when using the Command Line Interface. This window is also used to enable the DHCP auto configuration feature on the Switch. When enabled, the Switch is instructed to receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client automatically on boot-up. To employ this method, the DHCP server must be set up to deliver the TFTP server IP address and configuration file name information in the DHCP reply packet. The TFTP server must be up and running and hold the necessary configuration file stored in its base directory when the request is received from the Switch. For more information about loading a configuration file for use by a client, see the DHCP server and/or TFTP server software instructions. The user may also consult the Upload Log File window description located in the Tools section of this manual. If the Switch is unable to complete the DHCP auto configuration, the previously saved configuration file present in the Switch's memory will be used. This window also allows the user to implement the Switch's built-in power saving feature. When power saving is enabled, a port which has a link down status will be turned off to save power to the Switch. This will not affect the port's capabilities when the port status is link up. Users can also configure Password Encryption on the Switch. To view the following window, click Management > Management Settings, as show below: Figure 3-16 Management Settings window The fields that can be configured are described below: Parameter Description CLI Paging State DHCP Auto Configuration State Power Saving State Command Line Interface paging stops each page at the end of the console. This allows you to stop the scrolling of multiple pages of text beyond the limits of the console. CLI Paging is Enabled by default. To disable it, click the Disabled radio button. Enable or disable the Switch's DHCP auto configuration feature. When enabled, the Switch is instructed to receive a configuration file from a TFTP server, which will set the Switch to become a DHCP client automatically on boot-up. To employ this method, the DHCP server must be set up to deliver the TFTP server IP address and configuration file name information in the DHCP reply packet. The TFTP server must be up and running and hold the necessary configuration file stored in its base directory when the request is received from the Switch. Enable or disable the link down power saving mode of each physical port. The switch 38