Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 1000

www.dell.com | support.dell.com Related Commands reload upgrade (S-Series management unit) Reboot FTOS. Reset the designated S-Series stack member. show redundancy s Display the current redundancy configuration (status of automatic reboot configuration on stack management unit). Syntax show redundancy Command Modes EXEC EXEC Privilege Command History Version 8.3.3.4 Version 7.7.1.0 Introduced on S60 Introduced on S-Series Example Figure 40-2. show redundancy Command Output Force110#show redundancy Force10#show redundancy -- SSeries Redundancy Configuration -- Auto reboot : Enabled -- Stack-unit Status -- Mgmt ID: 0 Stack-unit ID: 0 Stack-unit Redundancy Role: Primary Stack-unit State: Active Stack-unit SW Version: 7.7.1.0 Link to Peer: Up -- PEER Stack-unit Status -- Stack-unit State: Standby Peer stack-unit ID: 1 Stack-unit SW Version: 7.7.1.0 -- Stack-unit Redundancy Configuration -- Primary Stack-unit: mgmt-id 0 Auto Data Sync: Full Failover Type: Hot Failover Auto reboot Stack-unit: Enabled Auto failover limit: 3 times in 60 minutes -- Stack-unit Failover Record -- Failover Count: 0 Last failover timestamp: None Last failover Reason: None Last failover type: None -- Last Data Block Sync Record: -- Line Card Config: succeeded Mar 07 1996 00:27:39 Start-up Config: succeeded Mar 07 1996 00:27:39 Runtime Event Log: succeeded Mar 07 1996 00:27:39 Running Config: succeeded Mar 07 1996 00:27:39 ACL Mgr: succeeded Mar 07 1996 00:27:39 1000 | S-Series Stacking Commands