Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 150
util-threshold mem S-Series
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 150 highlights
www.dell.com | support.dell.com util-threshold mem (S-Series) s Configure the high or low memory utilization thresholds for SNMP traps. Syntax util-threshold mem {Management-unit | standby | stack-unit unit-number | all} {high {0-100} | {low [0-100}}} To return to the default setting, enter the no util-threshold mem command syntax. Parameters unit utilization threshold in % Indicate the unit where you want to configure the memory utilization thresholds. • Management-unit • standby • stack-unit unit-number = select the number of the unit in the stack • all = use all of the units to configure the memory utilization information. Indicate the high or low values for the memory utilization in percentage format. • high. Range: 0 - 100 • low. Range: 0 - 100 Note: A threshold level of0 will disable the syslog and SNMP trap. Defaults High threshold default = 92% Low threshold default = 82% Command Modes CONFIG Command History Version 8.3.3.8 Version 8.3.5.3 Version 8.4.2.2 Version 8.4.2.0 Version 8.4.1.0 Introduced on S60. Introduced on S55. Introduced on C-Series, S25 and S50 Introduced on E-Series TeraScale Introduced on E-Series ExaScale Usage Information When the total memory utilization exceeds the configured threshold for a given time, a threshold notification is sent as a SNMP trap. If a low threshold value is not specified, the low threshold value is set to the same value as the high threshold value. 150 | Control and Monitoring