Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 248
set origin, set tag
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 248 highlights
www.dell.com | support.dell.com Version 7.5.1.0 pre-Version 6.1.1.0 Support added for C-Series Introduced for E-Series Usage If the set next-hop command is configured, its configuration takes precedence over the neighbor Information next-hop-self command in the ROUTER BGP mode. If you configure the set next-hop command with the interface's (either Loopback or physical) IP address, the software declares the route unreachable. Related Commands match ip next-hop neighbor next-hop-self Redistribute routes that match the next-hop IP address. Configure the routers as the next hop for a BGP neighbor. set origin c e s Configure a filter to manipulate the BGP ORIGIN attribute. Syntax set origin {igp | egp | incomplete} To delete an ORIGIN attribute setting, enter no set origin. Parameters egp igp incomplete Enter the keyword egp to set routes originating from outside the local AS. Enter the keyword igp to set routes originating within the same AS. Enter the keyword incomplete to set routes with incomplete routing information. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.3.3.1 Version 8.1.1.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.1.1.0 Introduced on the S60. Introduced on E-Series ExaScale Support added for S-Series Support added for C-Series Introduced for E-Series set tag c e s Configure a filter to specify a tag for redistributed routes. Syntax set tag tag-value To delete a setting, enter no set tag. Parameters tag-value Enter a number as the tag. Range: zero (0) to 4294967295. Defaults Not configured Command Modes ROUTE-MAP 248 | Access Control Lists (ACL)