Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 893
max-age, protocol spanning-tree rstp
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 893 highlights
Version 7.5.1.0 Version 6.2.1.1 Support added for C-Series Introduced for E-Series Usage Information The hello time is encoded in BPDUs in increments of 1/256ths of a second. The standard minimum hello time in seconds is 1 second, which is encoded as 256. Millisecond hello times are encoded using values less than 256; the millisecond hello time equals (x/1000)*256. When millisecond hellos are configured, the default hello interval of 2 seconds is still used for edge ports; the millisecond hello interval is not used. Related Commands forward-delay max-age Change the wait time before RSTP transitions to the Forwarding state. Change the wait time before RSTP refreshes protocol configuration information. max-age c e s Set the time interval for the RSTP bridge to maintain configuration information before refreshing that information. Syntax max-age seconds To return to the default values, enter no max-age. Parameters max-age Enter a number of seconds the FTOS waits before refreshing configuration information. Range: 6 to 40 seconds Default: 20 seconds Defaults 20 seconds Command Modes CONFIGURATION RSTP (conf-rstp) Command History Version 8.3.3.1 Version 7.6.1.0 Version 7.5.1.0 Version 6.2.1.1 Introduced on S60 Support added for S-Series Support added for C-Series Introduced for E-Series Related Commands max-age hello-time Change the wait time before RSTP transitions to the Forwarding state. Change the time interval between BPDUs. protocol spanning-tree rstp c e s Enter the RSTP mode to configure RSTP. Syntax protocol spanning-tree rstp To exit the RSTP mode, enter exit Defaults Not configured Rapid Spanning Tree Protocol (RSTP) | 893