Dell Force10 S60-44T FTOS Command Line Reference Guide for the S60 System FTOS - Page 580
IPv6 Route Map Commands, match ipv6 address
View all Dell Force10 S60-44T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 580 highlights
www.dell.com | support.dell.com Table 17-3. Output Explanations: test cam-usage Term Linecard Portpipe CAM Partition Available CAM Estimated CAM per Port Status Explanation Lists the line card or line cards that are checked. Entering all shows the status for line cards in the chassis Lists the portpipe (port-set) or port pipes (port-sets) that are checked. Entering all shows the status for line cards and port-pipes in the chassis. Shows the CAM profile of the CAM Identifies the amount of CAM space remaining for that profile Estimates the amount of CAM space the listed policy will require. Indicates whether or not the policy will be allowed in the CAM IPv6 Route Map Commands The following commands allow you to configure route maps and their redistribution criteria. • match ipv6 address • match ipv6 next-hop • match ipv6 route-source • route-map • set ipv6 next-hop • show config • show route-map match ipv6 address c e Configure a filter to match routes based on IPv6 addresses specified in an access list. Syntax match ipv6 address prefix-list-name To delete a match, use the no match ipv6 address prefix-list-name command. Parameters prefix-list-name Enter the name of IPv6 prefix list, up to 140 characters. Defaults Not configured. Command Modes ROUTE-MAP Command History Version 8.2.1.0 Version 7.8.1.0 Version 7.4.1.0 Introduced support on the E-Series ExaScale Introduced support on the C-Series Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to 16 characters long. Introduced support on the E-Series 580 | IPv6 Access Control Lists (IPv6 ACLs)